JP1 Remotes

I have a couple of questions on my RCU810 Remote. First, I do not know what I did when I was messing around in my Music Hall CD Code I created. It used to allow for VPT, but now it just ignores the code and acts as if VPT is set to off. Have you guys ever encountered anything like that?
Finally, I have tried to understand Toadtog to combine my discrete on/off codes for my Outlaw 950, but I cannot understand anything. I know it is an NEC1 signal with On being 187 and off being 181. I have also found the Pronto Discrete codes which are:

ON
0000 006D 0022 0002 0155 00AB 0016 0014 0016 0014 0016 0014 0016 0014 0016 0015 0016 0015 0016 0040 0016 0014 0016 0014 0016 0014 0016 0014 0016 0014 0016 0014 0016 0015 0016 0040 0016 0014 0016 0014 0016 0014 0016 0014 0016 0014 0016 0014 0016 0015 0016 0014 0016 0014 0016 0040 0016 0040 0016 0040 0016 0040 0016 0040 0016 0040 0016 0040 0016 0040 0016 06F8 0155 0055 0016 0E46

OFF
0000 006D 0022 0000 0155 00AB 0016 0014 0016 0014 0016 0014 0016 0014 0016 0014 0016 0014 0016 0040 0016 0015 0016 0015 0016 0014 0016 0014 0016 0014 0016 0014 0016 0014 0016 0040 0016 0014 0016 0040 0016 0040 0016 0014 0016 0014 0016 0014 0016 0014 0016 0014 0016 0014 0016 0014 0016 0014 0016 0040 0016 0040 0016 0040 0016 0040 0016 0040 0016 0040 0016 00AB

Any help on any of these three items would be greatly appreciated.

Thanks and Happy New Year,
Dan

VPT breaks when you change the natural device mode of a device button (eg, when you assign a VCR code to the CBL button, etc)

Rob,
Thanks for the help. I changed it to a VCR and put in on VCR1 and the VPT worked fine. Who could I ask for help regarding the Toadtog?

Thanks,
Dan

Post a question with a subject line like "Need help with ToadTog" and the right people will find you.

Rob,
Thanks for your help.

Thanks again,
Dan