JP1 Remotes

I have an Xbox with a generic DVD remote that dose not use the RCA protocol. I have tried to do a learn IR to figure out the protocol but most of the times I get an error. The few times I didn’t this is what I got.

Also if there is a better way to dothis let me know..


When i pressed "0" it saved as: Freq: 0
+20 -25742 +20 -131070 +20 -131070 +20 -131070

When i pressed "Rew" it saved as: Freq: 0
+20 -78428 +20 -131070 +20 -131070 +20 -131070

When i pressed "1" it saved as: Freq: 0
+20 -6522 +20 -28336 +20 -131070 +20 -131070

When i pressed "Pause" it saved as: Freq 34362
+548 -556 +1558 -630 +548 -1566 +1558 -630 +548 -1566 +548 -1566 +548 -1566 +1558 -630 +548 -1566 +548 -1566 +1558 -630 +1558 -630 +548 -1566 +548 -1566 +548 -9468 +548 -556 +1558 -630 +548 -1566 +1558 -630 +548 -1566 +548 -1566 +548 -1566 +1558 -630 +548 -1566 +548 -1566 +1558 -630 +1558 -630 +548 -1566 +548 -1566 +548 -130522

I'd guess bad batteries or bad learning technique. Search the forum for learn, there has been a lot written on that subject recently. The commands are badly corrupted.

There is an upgrade for a generic knock-off Xbox remote in the file section, be sure to try that also.