Remote may be too fast, how to slow it up?

bigbge · Post by **bigbge** » Mon Nov 01, 2004 1:57 pm

I have a OFA 8910. I downloaded the upgrade codes for the USDTV reciever. Everything works except the box seems unresponsive. I have to press each key a few times to get it to repond. Is there a simple way to slow down the remote transmissions or put a delay between bytes.

Suntan · Post by **Suntan** » Fri Dec 03, 2004 12:28 pm

Totally off the wall, but try taping over the small IR receiver next to the power button on the box with black electrical tape.

Long story short but I did this last night and it significantly helped reception. Although I didn't test it thuroughly so I can't say for sure this is the reason for better reception.

See the link here in the AVSforums for more info.

-Suntan

irv6744 · Post by **irv6744** » Fri Dec 17, 2004 12:16 pm

i had a device that originally had nec2 as the protocol and it was too fast also. it was suggested by rob that i change the protocol to nec1 and that turned out to be correct