JP1 Remotes

[BigAl]

Is there any way to place a timed delay in a macro sequence?

I've got a RS 15-2116 remote that I use to control my Toshiba TV, my UTV and a Media Center PC (MCE)... I've got a couple macros setup to turn on the system to watch either my UTV (i.e. discrete on for the TV, the UTV, set the TV to the UTV input) or my MCE machine. However, it takes a couple seconds for my TV to power up before it will respond to the input selection function.

Here's what I want for my macro commands:
1. Discrete power on for the TV
2. Discrete Power on for the UTV
3. Delay 4 seconds (any ideas how to do this?)
4. Set the TV to the UTV input

Al

[johann83]

There is a "pause" special protocol that you could try. I am using it in my 15-2104 and it works well.

This protocol is available at:
http://groups.yahoo.com/group/jp1/files/Special%20Protocols/pause.txt