View previous topic :: View next topic |
Author |
Message |
ianhawke
Joined: 04 May 2004 Posts: 7
|
Posted: Tue Jun 15, 2004 4:01 am Post subject: 9960 USb JP1 problem |
|
|
ok i know people have had this problem before, but i'm having problems and i've tried the past tests
i have a 9960 ( 9960 BJ3 printed on a sticker in the battery holder)
i have a USB JP1 cable and pogo bought from filebug
i have tried on different Pc with XP and 2000 and using different USB ports on front and back and on a hub (which crashed my pc )
i'm using ir 5.06 and older version tried with the USb drivers installed and tested with IR driver status
When i test with the battery's in i get
SDA is being held low. make sure Batteries are installed in the remote.
if i turn the cable so pin 1 is the other way i get
SDA is being held high.
When i test with batterys out, i get
SDA is being held low. make sure Batteries are installed in the remote.
both ways
and if i test not connected i get Remote not acknowleging so i know the cable can see the remote but i can't get past this point so i can start using the JP1 and start using my remote.
Any help or other test's to try would help, cheers |
|
Back to top |
|
|
Filebug JP1 Vendor
Joined: 21 Sep 2003 Posts: 74 Location: Mechanicsburg, PA |
|
Back to top |
|
|
ianhawke
Joined: 04 May 2004 Posts: 7
|
Posted: Tue Jun 22, 2004 3:56 am Post subject: |
|
|
Isssue now fixed
This works with my 9600, filebug USb cable
Cheers again |
|
Back to top |
|
|
|