"Unit Code" Location?

skyhook8 · Post by **skyhook8** » Mon May 17, 2004 9:14 am

Several posts have made reference to the "unit code" cell in the Setup tab of KM (v8.21) but I cannot see it.

I'm sure that the answer will require a "Doh" response on my part so I'll go ahead and offer it now:

Doh!

Thanks for your help.

johnsfine · Post by **johnsfine** » Mon May 17, 2004 9:24 am

It depends on the protocol selected. Some protocols include unit numbers. Most do not. Probably some with unit numbers don't make that obvious on KM's setup sheet (I'm not sure).

Some do have clear unit support. Try "GI 4DTV Official" for example.

skyhook8 · Post by **skyhook8** » Mon May 17, 2004 10:24 am

Thanks for the quick response.

I knew it was something simple. I had PhilipsTiVoNPU_ib_v_1_3.txt loaded and it doesn't show the "Unit Code" cell.

I have a Series 1 Hughes DirecTivo and when I loaded Tivo_Series_1.txt the Unit Code cell shows.

Hopefully that's the right one.