Page 1 of 1
I will pay for an expert to customize my remote for me.
Posted: Sun Jul 05, 2015 1:52 pm
by Kayaker
I have a URC 1056B01 remote with JP1.3 pins. I would like my new audio video pre-amp volume up/down and mute controls to work on it as my brand is not supported by my remote. I'm partial to this remote and just don't use the Harmony that I have programmed.
I'm just not computer savvy enough to get into JP1 programming and have no problem paying for this service.
Let me know if you can help.
Thanks
Posted: Sun Jul 05, 2015 4:15 pm
by vickyg2003
What is the make and model of the preamp? There is a lot that can be done from the keypad. Sometimes you don't need the computer if there is a built in signal that carries the correct fixed data.
Posted: Mon Jul 06, 2015 5:30 am
by Kayaker
That would be great if I could do it from the keypad. My pre-amp is a Bryston SP3.
Posted: Mon Jul 06, 2015 8:04 am
by vickyg2003
The Bryston uses an unrecognized protocol. So this can't be handled via the keypad. We can create an upgrade but the upgrade needs to be loaded via a jp1 cable......
Posted: Mon Jul 06, 2015 10:38 am
by MrMoody
Where are you located? Perhaps someone lives close to you.
Posted: Mon Jul 06, 2015 10:40 am
by Kayaker
If you're willing, I could ship you the remote. Other routes might take more hand holding than either one of us is comfortable with.
I might even have 2 done so I have a backup. Let me know, thanks.
Posted: Mon Jul 06, 2015 10:43 am
by Kayaker
I'm just outside Toronto.
Posted: Wed Jul 08, 2015 5:52 am
by Kayaker
I have the HEX codes. Can anyone help?
Posted: Wed Jul 08, 2015 8:22 am
by mdavej
Feel free to bump this thread as often as you like. Hopefully one of our Canadian members will offer to help. I'd do it myself if you were anywhere but Canada. I've shipped things all over the world without issue. But the last time I shipped something there, it was an expensive customs nightmare. Never again.
Alternatively, if you buy a cable, we could build the file for you so all you'd have to do is plug in and click download.
Posted: Wed Jul 08, 2015 12:17 pm
by vickyg2003
Kayaker wrote:If you're willing, I could ship you the remote. Other routes might take more hand holding than either one of us is comfortable with.
I might even have 2 done so I have a backup. Let me know, thanks.
We are pretty good at hand holding here. We all stared out as newbies. Getting a good cable is very inportant. With a cable you can add some very sophisticated features besides contolling your preamp.
Posted: Sat Jul 11, 2015 5:33 am
by Kayaker
I'll get the cable ordered and we can go from there
Posted: Sat Jul 11, 2015 7:44 am
by mdavej
Please post what you plan to buy.