JP1 Remotes Forum Index JP1 Remotes


FAQFAQ SearchSearch 7 days of topics7 Days MemberlistMemberlist UsergroupsUsergroups RegisterRegister
ProfileProfile Log in to check your private messagesLog in to check your private messages Log inLog in

Instructions to set the C17D2090 atomic clock (WIC#693047)

 
Post new topic   Reply to topic    JP1 Remotes Forum Index -> Non-JP1
View previous topic :: View next topic  
Author Message
The Robman
Site Owner


Joined: 01 Aug 2003
Posts: 18563
Location: Chicago, IL

PostPosted: Mon Jun 22, 2015 10:08 am    Post subject: Instructions to set the C17D2090 atomic clock (WIC#693047) Reply with quote

I have this little travel atomic clock, which I just bought ages ago because it has a built in thermometer, but it's not able to receive the atomic time in my building, so every time I change the batteries I need to figure out how to set the clock, so I figured I might as well write the instructions down to help others.

A. To manually set the clock

1. Use the CAL/ALM button to toggle the display until it shows the calendar
2. Press and hold SET until the screen flashes "12hr"
3. Use the UP (antenna) and DOWN (alarm) buttons to change the settings
4. Press SET to set the value

This mode will let you set the 12/24 hours clock, the time, date and year. You should be in the right time zone before you start.

B. To set the alarm1 time

1. Use the CAL/ALM button to toggle the display until it shows the AL1 alarm time
2. Press and hold SET until the alarm time flashes
3. Use the UP (antenna) and DOWN (alarm) buttons to change the settings
4. Press SET to set the value

C. To set the alarm2 time

1. Use the CAL/ALM button to toggle the display until it shows the AL2 alarm time
2. Press and hold SET until the alarm time flashes
3. Use the UP (antenna) and DOWN (alarm) buttons to change the settings
4. Press SET to set the value

D. To turn on alarm1

1. Use the CAL/ALM button to toggle the display until it shows the AL1 alarm time
2. Use the DOWN (alarm) button to toggle the alarm on and off (a bell appears on the screen)

E. To turn on alarm2

1. Use the CAL/ALM button to toggle the display until it shows the AL2 alarm time
2. Use the DOWN (alarm) button to toggle the alarm on and off (a bell appears on the screen)

F. To have the atomic clock set automatically

1. Press and hold the UP (antenna) button until a little triangle flashes on the screen
2. Wait for clock to set
3. To give up waiting, press the UP (antenna) button again.

G. To change the time zone

1. Tap the ZONE button to toggle between the 4 time zones

Note: if the clock has been set manually and is not receiving atomic updates, it will not observe daylight savings time, so you will need to manually adjust the time. A quick and easy way to handle this would be to just change the time zone.






_________________
Rob
www.hifi-remote.com
Please don't PM me with remote questions, post them in the forums so all the experts can help!
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic       JP1 Remotes Forum Index -> Non-JP1 All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


 

Powered by phpBB © 2001, 2005 phpBB Group
Get Smart! the band's official homepage Rockabilly Central