JP1 Remotes

Are RC5 and RC-5 protocols different? In learning mode, my Helvar Digidim (for switching and dimming light) apparently sends RC5 protocol. The target remote functions as expected.
In trying to copy functions to a device (update file) I can't select RC5 protocol; RC-5 is available. I chose this, but the resulting device does not work.
Similarly created NEC devices do work, so I guess my device creating method is OK. Any suggestions?

hefvogt wrote:Any suggestions?

Zip together the relevant files, (the learns, the upgrade and the IR/RMIR file), and post them in the diagnosis section. Then post a link to that file in this thread and we will have a look.

vickyg2003 wrote:

hefvogt wrote:Any suggestions?

Zip together the relevant files, (the learns, the upgrade and the IR/RMIR file), and post them in the diagnosis section. Then post a link to that file in this thread and we will have a look.

Thanks for your attention. In collecting files to zip them to you I found an error in the device definition: the setup code had accidently been set to 0000, where 2104 was intended. Sorry for the inconvenience.