JP1 Remotes

I have managed to create a CCF file of the remote I need, but I am absolutely stumped as to what to do next. Beyond dropping the CCF on to DecodeCCF.exe and getting a TXT file out of it, none of the instructions actually say what to do with it next. (Very frustrating) Can someone point me in the direction of the next steps?

Thanks

I've had a little too much to drink to really be helpful, but I remember writing this up in the wiki. Perhaps this will help

http://www.hifi-remote.com/wiki/index.p ... Pronto_Hex

If the decodes don't make sense ie say GAP then make sure to force the timings as stated below the CCF file example.

If you just don't know how to use RemoteMaster then post the results so that we can interpret them.