Page 1 of 1
replaytv 5000 remote button changes (channel up-down w/TV)
Posted: Sat Feb 14, 2004 2:58 pm
by rider1966
Help! I think I'm very, very, very close to changing my replaytv 5000 remote's (standard is replay's) channel up/down to my Sony-TV' channel up/down. Due the the fact I never use the these buttons since channel surfing is too slow on replay (always use guide), I wanted to convert these two buttons so I can control my tv (I already can control volume, power, and mute!). I just received my JP1 cable yesterday, loaded all the necessary software, pasted the changes from RemoteMaster to IR, uploaded the changes, power light flashed a couple times, and nothing! No message from IR and the remote works the same. Appreciate any help.
Posted: Sat Feb 14, 2004 5:02 pm
by The Robman
To do this, you will need to use the device combiner. The channel buttons are only active in Replay mode, not TV mode.
Posted: Mon Feb 16, 2004 7:18 pm
by sfhub
Also, ch+/- is very useful for Replay Guide navigation (both channel and
replay) since it is page up/down.
Posted: Mon Feb 16, 2004 7:38 pm
by The Robman
sfhub wrote:Also, ch+/- is very useful for Replay Guide navigation (both channel and replay) since it is page up/down.
I was originally going to post that also, then I remembered that this is the R5k remote, that has page up/down buttons in addition to channel up/down buttons.
Posted: Mon Mar 01, 2004 2:52 pm
by sfhub
The Robman wrote:I was originally going to post that also, then I remembered that this is the R5k remote, that has page up/down buttons in addition to channel up/down buttons.
I looked real hard and couldn't fine the separate page up/down buttons
on the 5k remote. Is it possible a different remote was being referenced?
Posted: Mon Mar 01, 2004 3:47 pm
by The Robman
sfhub wrote:The Robman wrote:I was originally going to post that also, then I remembered that this is the R5k remote, that has page up/down buttons in addition to channel up/down buttons.
I looked real hard and couldn't fine the separate page up/down buttons
on the 5k remote. Is it possible a different remote was being referenced?
You know, you're right. I must have been thinking of the R4k remote (see below). Which of course brings us back to the original point that it's not a good idea to kill the CH +/- buttons because they do more than just change channels.
