Page 1 of 1
Looking for ir code for Ilink 8000
Posted: Mon Jan 10, 2011 12:11 am
by Clambucks
Looking for the ir remote control code for the Ilink 8000. I found one for the Ilink 9000 but it doesn't work on my 8000 model. Thanks
Posted: Mon Jan 10, 2011 2:35 am
by alanrichey
Posted: Mon Jan 10, 2011 8:49 am
by Clambucks
Thanks for the quick reply, I just tried it and it doesn't work. It looks like the file that I had already tried that says it is for the ilink 9000 Plus this file was (RV) I think I need an (PL) file
Posted: Mon Jan 10, 2011 8:55 am
by alanrichey
Clambucks wrote:Thanks for the quick reply, I just tried it and it doesn't work.
You obviously didn't bother to check the Readme file, particularly the part that starts: "If you have problems please do NOT just report back it 'doesn't work', that is totally useless for someone trying to understand what is going on...."
Clambucks wrote:It looks like the file that I had already tried that says it is for the ilink 9000 Plus this file was (RV) I think I need an (PL) file
What are you talking about ? The link I posted contains both the RV and the PL BIN files.
Care to start again ?
Posted: Mon Jan 10, 2011 9:27 am
by Clambucks
Ok, I just deleted all the files on my computer and started over and read the readme notes. I have a hava gold instead of a slingbox but am pretty sure the files are the same for both boxes. I installed the files in my hava player and am unable to power the box off or change channels, etc..
I tried the camera trick and placement of the ir blasters and both are operational.
Maybe I need a code specific for the hava
Sorry for the confusion, I just thought the hava gold and slingbox used the same files.
Posted: Tue Jan 11, 2011 1:34 am
by alanrichey
I don't know anything about the Hava Gold, but I know the Vulkano uses the Axum chip. Is that likely to work ?
Posted: Tue Jan 11, 2011 5:45 am
by Clambucks
I just checked mine and it says IR blaster version =PL
Posted: Mon Jan 31, 2011 7:07 pm
by Clambucks
Good news I tried the Conaxsat (CNX) Nano 2 file for slingbox and it changes channels and powers my ilink 8000 on and off.
Posted: Tue Feb 01, 2011 1:47 am
by alanrichey
Yes they use identical codes. In fact I suspect I built the iLink8000 remote by just renaming the Nano2 one. So I have no explanation as to why one works and no the other.