JP1 Remotes

I installed the pause protocol on this, and it does work, but not very well. No matter how long I set the pause, it is always about 3/4 of a second. For example, if I set it to $10 or $20 or $30, they all still seem to be about 3/4 of a second. Not the end of the world though, I just used several phantom1 key presses in my macro to make the pause longer. Has anyone else noticed this behavior, or am I doing something wrong?

To properly diagnose whether you're doing something wrong, or not, we would need to see your IR file.

srturner47 wrote: BTW, I installed the pause protocol on this, and it does work, but not very well. No matter how long I set the pause, it is always about 3/4 of a second. For example, if I set it to $10 or $20 or $30, they all still seem to be about 3/4 of a second. Not the end of the world though, I just used several phantom1 key presses in my macro to make the pause longer. Has anyone else noticed this behavior, or am I doing something wrong?

As Rob said post your files. Without them, you are asking us to guess. However I think I have a pretty good GUESS. In some of the newer remotes UEI has hijacked the PID that we used the pause protocol. If you are using RM, RM doesn't provide a protocol to copy, because it thinks that the pause protocol is built in. So when the pause is executed its sending a signal that takes about 3/4 of a second, instead of waiting x amount of time.