Page 1 of 1
Buffalo DTV-H300
Posted: Fri Sep 03, 2010 6:15 pm
by eferz
Tiborg,
I imported your guid.xml into the JP1 tools, and it appears that all of your learns were untested. The result of which I was only able to obtain four clean learns, one dirty learn, and nine malformed learns. Do me a favor and go back through the Betaremotes webpage again and edit your remote profile. This will allow you test each of the buttons and relearn them as necessary.
*** Files deleted due to irrelevance ***
Posted: Sat Sep 04, 2010 12:45 am
by tiborg
Strange, I did test every key I created. I'll go through it again to see if that helps.
Posted: Sat Sep 04, 2010 12:57 am
by tiborg
I went through and confirmed each key again, is it showing up any differently now?
Posted: Sat Sep 04, 2010 1:35 am
by eferz
tiborg wrote:I went through and confirmed each key again, is it showing up any differently now?
https://secure.sling.com/irservices/res ... d8ba2a.xml
That's the URL for the GUID that you gave me. Is it possible that you gave me an older learntremote guid? Might want to check if you had performed multiple learns.
Posted: Sat Sep 04, 2010 2:30 am
by eferz
https://secure.sling.com/irservices/res ... 6ca888.xml
I just checked the the GUID from the other post. Looks like I used the wrong one, so I rechecked the correct one above. And it doesn't seem to have a remote associated with it.
Posted: Sat Sep 04, 2010 6:01 am
by tiborg
So that link is referencing the box and not the remote? It could be cause I'm still on analog service, so I'm using the internal tuner. I'll getting my FiOS TV connection at the end of the week. After that the box will be set to use the DTV-H300's remote by default.
Posted: Sat Sep 04, 2010 10:19 am
by eferz
tiborg wrote:So that link is referencing the box and not the remote? It could be cause I'm still on analog service, so I'm using the internal tuner. I'll getting my FiOS TV connection at the end of the week. After that the box will be set to use the DTV-H300's remote by default.
It appears that I've made a couple of mistakes. First, I used the wrong GUID and then I shorted the URL. I apologize for that.
Once I used the correct GUID and used the proper URL, I was able to create bins for your to test.
Instructions are inside either zip archive.
Posted: Sat Sep 04, 2010 9:35 pm
by tiborg
Thanks, I'll test it out the next time I have the digital tuner hooked up.