JP1 Remotes

Hello,

I need remote control custom code for Slingbox AV of DT-PHI9100 (model name on receiver).
On Pace web site it is coded as TDS850IDI.
I am using Digiturk HD in Turkey.

I have tried the codes on https://www.hifi-remote.com/forums/viewt ... t=tds850ns but i got an error when i use them. Error message is "custom remote code not found". I have changed the file to PL, RV, JU with RM but no change.

My slingbox is purchased from USA. I am not sure if it PL or RV.

Can anyone please help me?

Thank you in advance.

Have a nice day.

The Pace 850 has proved very difficult in the past, as you can see from other threads. However, we think we have finally sorted out the problems with the XMP (Dreambox) protocol so have a go with this one:

https://www.hifi-remote.com/forums/dload ... le_id=8567

The only oddity is that it does not a Power Toggle function just a Power oN and a Power off. The Power On function returns the same code as the Channel Down (go figure), so I out the Power Off command on the Power button. So it will fail the Power test during setup, but just keep going and complete the setup.

I am a bit concerned about your error message as that may indicate you have a VERY old JU Slingbox Classic and so far we haven't managed to get remotes working on that one.

Al

Thank you a lot. It seems it is working fine. Power is working on test.

Have a nice day.

Here's the RM file:
https://www.hifi-remote.com/forums/dload ... le_id=8574

so bottom line what is the code?

thanx

zazat wrote:so bottom line what is the code?

thanx

XMP protocol, device 41, sub-device 17.

i use same digiturk
PAce DT-PHI9100

i cant understand what i write to code box?

i new guy for this

You need this file

https://www.hifi-remote.com/forums/dload ... le_id=8590

Al