View previous topic :: View next topic |
Author |
Message |
GManca101
Joined: 28 Dec 2004 Posts: 5
|
Posted: Wed Feb 24, 2010 9:21 pm Post subject: URC-6131n post-mod: needs protocols? |
|
|
Hello, I just got two 6131n's that needed the eeproms and jp1 headers installed; got the first one going and it loads all upgrades with no problems. However on the second one, unless I include a protocol for the device I'm upgrading, the remote will half-blink and then blink twice after pressing a command, i.e power. I did successfully do the 981 code to verify that the eeprom was installed, chip is in correct orientation, and went over all solder points again.
Is there a way to reinstall all the protocols or will I have to install each device's protocol as well as the device upgrade info?
Any help would be most appreciate it! |
|
Back to top |
|
|
The Robman Site Owner
Joined: 01 Aug 2003 Posts: 21234 Location: Chicago, IL |
Posted: Wed Feb 24, 2010 10:02 pm Post subject: |
|
|
Try putting fresh batteries in the 2nd remote. _________________ Rob
www.hifi-remote.com
Please don't PM me with remote questions, post them in the forums so all the experts can help! |
|
Back to top |
|
|
GManca101
Joined: 28 Dec 2004 Posts: 5
|
Posted: Thu Feb 25, 2010 1:05 am Post subject: |
|
|
Many thanks Rob, I would have never thought it would be the batteries. Is it that the remote is constantly resetting itself due to low power? |
|
Back to top |
|
|
The Robman Site Owner
Joined: 01 Aug 2003 Posts: 21234 Location: Chicago, IL |
Posted: Thu Feb 25, 2010 8:45 am Post subject: |
|
|
It sounds like the remote's low battery indicator kicking in.
You'd be surprised how often new batteries are the answer to the problem. _________________ Rob
www.hifi-remote.com
Please don't PM me with remote questions, post them in the forums so all the experts can help! |
|
Back to top |
|
|
|