JP1 Remotes

1. Device:Ilo 32" HD LCD (ILO-32HD)
2. Type of device: LCD TV
3. Year:2007
4. JP1/UEI Remote model:6131nw PVR 2K
5. Do you have a JP1 cable? Yes
6. Still have original remote? Yes
7. Checked the file section? Yes
8. Checked Pronto file section (at R/C)? No
9. Partially working setup code? No
10. Learning remote question? No

First I would like to thank all members who post here because just from reading the guides I have built a serial interface and completed the mod on the 6131 (that's a small EPROM ).

I have been able to upgrade the remote to work a sat receiver with a upgrade from the file section and need to find a upgrade for the Ilo 32"LCD (TV would have to come off the wall for exact model #).
Have tried the upgrades for the Ilo 27" & 2300 in the file section with no luck working the TV.
Also have tried codes and files for Emerson

Any help is appreciated. Thanks!

P.S.
And for all of you who like to mod stuff. The Linksys WRT54G-TM T-Mobile Edition wireless router that sell for $19.99 now (at one time they were $80 but they can't get rid of them) at T-Mobile stores can be firmware updated to work like a $600 router.
Instructions here: http://www.dd-wrt.com/phpBB2/viewtopic. ... 455#212455

Again Thanks for all the help

If getting the real model number isn't feasible, you'll need to find a way to capture the signals from the OEM remote.

OK after some digging I found the manual.
And are you ready for this. The model # is ILO-32HD.
I should have been able to make a WAG and got that one
And after further review of my original post I did

Thanks again

Try this...
https://www.hifi-remote.com/forums/dload ... le_id=6776

You are The (Rob) Man
It worked
Now I have some more reading to do because I want the VOL. control to work when I am in CBL/SAT and the power button to turn off/on both Tv & Receiver

Thanks for your help

superedo wrote:I want the VOL. control to work when I am in CBL/SAT and the power button to turn off/on both Tv & Receiver

That's the VPT (Volume Punch Thru) settings on the first tab in IR. For master power, make a macro that powers both. If you can find discrete on/off codes, that's even better.