JP1 Remotes

Hello

I am building my own little database for a couple of devices so that my friends can easily just use my 4-digit codes to adjust to their setup.

Now I have a Thomson receiver that uses the Thomson protocol but also two different devices (device # 3 and device #35).

The keys that I learn from that remote give me the same OBC/HEX but differ in their device number.

Since I have to select ONE SINGLE protocol in RemoteMaster with ONLY ONE Device number I cannot program these keys simultaneously.

Is there a way out?

You would either need a Thompson Combo protocol (if one exists) or you could use the Device Combiner. Could you post some more info about the signals/codes in question. For example, what setup codes are you using and could you post your IR file which contains the learns.

Thank's again for you quick reply...!

I dont have a Thomson combo protocol in RemoteMaster. The device combiner - I guess - wont work for me, since it creates key moves (is that right). And key moves cant be associated with a 4-digit database code, since they remain for all the code setups.

I have uploaded two files to the diagnostic area:
1. the learned file
https://www.hifi-remote.com/forums/dload ... le_id=6150

2. my rmdu file, that I created based on the previous
https://www.hifi-remote.com/forums/dload ... le_id=6149

I hope that helps a little ....

Try this upgrade and see if it works:

Upgrade Code 0 = 37 D0 (SAT/2000) Thomson receiver (KM v9.16)
4B 07 6E FA 02 EE 31 3F A8 AA F4 B4 B0 84 74 CC
96 94 92 90 98 78 E4 CA 9A C6 82 66 AE CE AC
End

Thank you for your upgrade.

Unfortunately, my receiver broke down suddenly and now I have to wait for it to be repaired.

As soon as it gets back I will try the code

Greetings....

Now I finally got my receiver back-

Thanks very much - the code works now