Page 1 of 1

Newbie with Nevo C3: all tabs empty after "download&

Posted: Thu Jul 04, 2024 3:35 pm
by ThunderOwl
Hello All! Just got Nevo C3 today, found out about JP1 today, and installed Java RMIR today :)
I think I have set registry changes as needed, RMIR says right on top bar "Nevo C3". But, when I press "download", progressbar is active, but after that - all tabs of RMIR are empty. Please, what did I miss, what I didn't do, or did wrong? Thank You! :-)

FIXED - please see my last post in this thread. "Factory Reset" helped. ;-)

Posted: Thu Jul 04, 2024 6:48 pm
by mdavej
There may be some clues in your rmaster.err file. But my initial guess is you have RMIR in a folder that is lacking write permissions. So move it to Documents or Downloads or something like that.

Posted: Fri Jul 05, 2024 3:04 am
by ThunderOwl
Thank You for answering! Folder is under My Documents, it is fine, thanks for the tip about logfile! I will show the end of it, looks like there is something weird going on when getting devices.xcf, hmm:
(P.S.: I did try to "Reset" remote)

36 region
37 sys
38
39
3a
3b ?"
3c ?????????ename
3d directv_rf
3e enabled
3f assistant
40 powerkeys
41 audioinputs
42 pictureinputs
43 hardkey
44 softkey
45 sendir
Parsing error in devices.xcf
Data parsing ended
File home.xcf: bxmlStart=0 xcfStart=4c

File system.xcf: bxmlStart=0 xcfStart=c0

File home.xcf: bxmlStart=0 xcfStart=4c

File system.xcf: bxmlStart=0 xcfStart=c0

0000: 7 != 3
RemoteMaster.windowClosing() entered


mdavej wrote:There may be some clues in your rmaster.err file. But my initial guess is you have RMIR in a folder that is lacking write permissions. So move it to Documents or Downloads or something like that.

Posted: Fri Jul 05, 2024 6:37 am
by mdavej
Looks like issues with some device names. Can you change or delete the first few up to DirecTV on the remote itself and try again?

Posted: Fri Jul 05, 2024 6:58 am
by ThunderOwl
EDIT - I did now FACTORY RESET (Press "Reset", then type "981", then press "Factory Reset"), not the "usual reset", and now download from my remote happens normally! That's nice progress here ;-)
Have to say - good first impression from Community here, thank You guys!

Posted: Fri Jul 05, 2024 2:15 pm
by mdavej
Glad you got it working. If you need any icons, check out this thread. I've made some recent updates.
https://www.hifi-remote.com/forums/viewtopic.php?t=16296