TDC-38 Official - protocols.ini entry

Post by **The Robman** » Mon Dec 09, 2019 5:41 pm

Is the entry for this executor correct? It appears that the LSB of the sub-device code falls outside of the fixed data, so 2 different sub-device codes result in the same hex code (ie, 10 and 11 are the same, likewise for 12 and 13, etc).

Post by **mathdon** » Tue Dec 10, 2019 4:27 am

Rob, you need to look at the translators in the protocols.ini entry to see what is going on. There is the line

Code: Select all

CmdTranslator=TranslatorFromDev(1,1,0) Translator(0,7,1)

which shows that the LSB of the sub-device is encoded in the variable byte, not the fixed bytes.

Post by **The Robman** » Tue Dec 10, 2019 7:26 am

Ah, good to know. I've been reading protocols.ini a LOT recently but I missed that line.