JP1 Remotes

IN this example, I have added a macro and assigned it to Soft1 on one of my devices. Within the device editor under the layout tab, the correct button is highlighted, in the case the top left button for Soft1. However, when I upload the config to the remote, the macro actually ends up being assigned to the bottom left button.

Is there a way to fix this?

I have tried searching through the forum without success. I appreciate any assistance.

This is probably what you're seeing, for which there is no fix.
http://www.hifi-remote.com/forums/viewt ... 309#132309

If not, you'll need to post your RMIR file(s) so we can have a look.