JP1 Remotes Forum Index JP1 Remotes


FAQFAQ SearchSearch 7 days of topics7 Days MemberlistMemberlist UsergroupsUsergroups RegisterRegister
ProfileProfile Log in to check your private messagesLog in to check your private messages Log inLog in

How to deal with the problems of IC burning up?

 
Post new topic   Reply to topic    JP1 Remotes Forum Index -> Electronics Repair
View previous topic :: View next topic  
Author Message
Bolling



Joined: 16 Jun 2017
Posts: 1

                    
PostPosted: Fri Jun 16, 2017 4:45 am    Post subject: How to deal with the problems of IC burning up? Reply with quote

I looked at a friend's guitar amplifier which wasn't working, the problem was clearly (because it fell off) a broken IC (TDA2030AC).

After replacing it, the amplifier started working again but when I was taking some measurements I made a short-circuit and burned it.

When I replaced the TDA2030AC again, the sound was very soft and distorted. I checked the datasheet and the circuit is a bit different than the recommended implementation. Some resistor and capacitor values are different, but it's a dual-supply non-inverting configuration.

The strange thing is that while making contact between pins 2 and 3 with my fingers it sounds fine. And the same occurs with a resistor between about 100 to 500 kohms (see red line in my diagram). Even if that solution works, I would like to understand what's going on and if there is likely another part of the circuit damaged.

I've post the circuit (excluding the rectifier and pre-amplifier) in the attachment.

And this is the reference circuit in TDA2030's datasheet: http://www.kynix.com/uploadfiles/pdf9675/TDA2030AH.pdf (Figure 13: typical amplifier with split power supply)

I would appreciate any clarifications, thanks.
Back to top
View user's profile Send private message
The Robman
Site Owner


Joined: 01 Aug 2003
Posts: 21197
Location: Chicago, IL

                    
PostPosted: Fri Jun 16, 2017 7:47 am    Post subject: Reply with quote

You got your answer for this over a year ago:
https://electronics.stackexchange.com/questions/228943/distortion-in-tda2030-circuit

Then you got more answers here:
https://www.questarter.com/q/distortion-in-tda2030-circuit-26_228943.html

And even more here:
https://forum.guitar.com/amplifiers-23/why-does-circuit-burn-after-i-replaced-tda2030-ic-226880

So, what else do you need to know?
_________________
Rob
www.hifi-remote.com
Please don't PM me with remote questions, post them in the forums so all the experts can help!
Back to top
View user's profile Send private message Visit poster's website
Display posts from previous:   
Post new topic   Reply to topic       JP1 Remotes Forum Index -> Electronics Repair All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


 

Powered by phpBB © 2001, 2005 phpBB Group
Top 7 Advantages of Playing Online Slots The Evolution of Remote Control