JP1 Remotes

Hello
I am new in here
I built successfully the interface for JP1.3 remote
When I connected it to the remote I got signature -30643064
Could you help me guys to build an RDF file for this remote
I downloaded the Eprom content (this remote is very similar to URC6022)

https://www.hifi-remote.com/forums/dload ... le_id=5733

thanks any way

Until an expert gets a chance to look at the remote, you could always try to use the RDF for the 6022 if you think these are close. Make a copy and change the name to match the signature in the remote you are trying to use.

Can't hurt since you already have the "virgin" IR file. If the remote goes nuts, you can always just reload the virgin file from your backup and you'll be good as new.


-bill

Thanks for your reply
I did it already but I got a lot of errors,
I will upload the file that in the end work for me
But still I need to configure the upgrade address so I will need an expert help
Also with all the experiments, the remotes stop responding(no led)

RDF
https://www.hifi-remote.com/forums/dload ... le_id=5742

MAP and IMAGE
https://www.hifi-remote.com/forums/dload ... le_id=5741

Better late than never, I have updated the RDF for this remote:
https://www.hifi-remote.com/forums/dload ... e_id=27169

It appears to have 2 upgrade sections, which I don't know how to handle, so I've just programmed the first.