Thomson DCI 5211 HOT Cable Box

Post by **vickyg2003** » Wed Sep 15, 2010 4:45 am

Well it hasn't been tested on the actual device, but the at least now, when we fill in the variables we get from the Thomson, the signal shoots what we expect.

I thought it was just a sling problem, but it was a problem for all the remotes too.

ron_by · Post by **ron_by** » Sat Sep 18, 2010 5:27 pm

Hey there,

Sorry for taking so long checking back here, I'm real busy with school stuff. And thanks to Rob for drawing my attention. And of course thanks to all of you guys for all the effort, it's really awesome.

Unfortunately it still doesn't seem to be working. I put the new files in place, put the code in, but nothing... no response, none of the buttons seem to work.

alanrichey · Post by **alanrichey** » Sun Sep 19, 2010 6:10 am

Pity. Not sure where we go from here. I assume you did all the checks I suggested ?

Post by **vickyg2003** » Sun Sep 19, 2010 6:39 am

This could be dependent on the Slingbox RDFs. The Thomson uses 004B. Two of the RDF's had 004B built in, and the RDF's had the wrong version (variant 7), but were reporting variant 1. So if this was a PK or an RV slingbox, the data being sent is the wrong information.

So it could be just an RDF issue that would have been corrected by the RDF's that I had loaded up to the development area ealier this week.

alanrichey · Post by **alanrichey** » Sun Sep 19, 2010 7:03 am

OK, I have rebuilt the BIN files using your RDFs.

https://www.hifi-remote.com/forums/dload ... le_id=8927

Let's see if that works.

ron_by · Post by **ron_by** » Wed Sep 22, 2010 3:51 pm

the new files are not working either i'm sorry to report. i appreciate all the trying though, so thanks very much for that.

alanrichey · Post by **alanrichey** » Thu Sep 23, 2010 12:27 am

Run out of ideas I'm afraid