Page 2 of 2
Posted: Sat Aug 21, 2004 8:38 am
by mr_d_p_gumby
Mark Pierson wrote:You really need to try and program a macro that contains the hard SCAN button (must be done on the remote). This should at least confirm the key code.
Until Felipe confims this, I think it would be safe to assume the keycode is $03. It's listed in the RDF [General] section under
FavKey=3, $02B, 15, 4 (first argument is keycode), which would tend to imply that someone researched this at some point.
Posted: Sat Aug 21, 2004 11:16 am
by Mark Pierson
mr_d_p_gumby wrote:It's listed in the RDF [General] section under FavKey=3, $02B, 15, 4 (first argument is keycode)
I guess I need to pay a little more attention to detail when looking at an RDF... I missed that one, too.
I'll make the necessary changes to KM for the next release.
Posted: Sat Aug 21, 2004 11:45 am
by 15-1994
THANKS MARK
Felipe
Posted: Sat Aug 21, 2004 1:12 pm
by Mark Pierson
Ok.. try
v8.27. Remember, you need to be using one of the hacked protocols that supports programming the SCAN function directly. Otherwise, KM will not make it available on the Buttons sheet.
Also, if you have any Cable type upgrades, the fav (soft) button has been moved, so they will need to be updated accordingly.
Posted: Sun Aug 22, 2004 1:06 am
by 15-1994
Mark Pierson wrote:
Ok.. try v8.27. Remember, you need to be using one of the hacked protocols that supports programming the SCAN function directly. Otherwise, KM will not make it available on the Buttons sheet.
Mark and Mike,
Now, everything is working perfectly , THANK YOU GUYS
Felipe