Posted: Sat Nov 20, 2004 9:56 am
If there ws a link, I'd follow it.
If I knew how to post the link I would, Its on the yahoo site in the photos section. The folder is called DTV White Remote.
DTV White
Hope the link works
JP1 Remotes
Forum for JP1 remotes
http://www.hifi-remote.com/forums/
Bad News: Next-gen DirecTV remote = no JP1
Page 2 of 2
Posted: Sat Nov 20, 2004 11:55 am
LOL
If I knew how to post the link I would, Its on the yahoo site in the photos section. The folder is called DTV White Remote.
DTV White
Hope the link works
If I knew how to post the link I would, Its on the yahoo site in the photos section. The folder is called DTV White Remote.
DTV White
Hope the link works
Posted: Sat Nov 20, 2004 12:58 pm
My guess is that the J2 spot is there for a modem or an RF puck (I'd need to follow the traces to know for sure), I don't think it's any sort of JP1 connector.
However, I notice that there is an EEPROM onboard, which is very good news. That means you can almost certainly fashion a JP1 connector for this remote if you were to chose to do so.
You would need to use the many instruction sheets that have been written up for other non-JP1 remotes, such as the REM400, URC-7200, etc as a guide.
However, I notice that there is an EEPROM onboard, which is very good news. That means you can almost certainly fashion a JP1 connector for this remote if you were to chose to do so.
You would need to use the many instruction sheets that have been written up for other non-JP1 remotes, such as the REM400, URC-7200, etc as a guide.
Posted: Sat Nov 20, 2004 1:41 pm
Rob, I should be getting two of the D10 remotes in mail in couple days, I'll send you one.
Posted: Sat Nov 20, 2004 3:00 pm
Yoo da (Masked) man!