Page 2 of 2
Posted: Fri Apr 16, 2004 10:29 am
by toranoko
Great job everybody, it finally works. Thank you very much and keep up the good work.
Posted: Fri Apr 16, 2004 11:37 am
by The Robman
So SAT/1146 was the right code then, great. Could you download the KM file and make sure that all the buttons are described correctly. For example, there was two sets of CH +/- buttons in the list I was given, one set that was also labelled as "PAGE +/-" and another set that used the same codes as the arrow up/down buttons.
You could also try creating an upgrade using any unaccounted for OBCs to see if you can find any additional functions or discrete codes.
If you end up making any changes, by all means reload the KM file.
Posted: Fri Apr 16, 2004 12:57 pm
by toranoko
Yes SAT/1146 was the right code. I checked all key codes, and the only one that I found that was not in the downloaded file was TV/RADIO that is not present on the original remote. The code for this button is 198 (EFC). As for the CH+/CH-, those with the same code as UP/Down work as ch+/ch- in view mode, and as up/down in menu mode. The others CH+/CH- labelled as Page+/- work as ch+/ch- in view mode and Page +/- in list mode (TV list or Radio list).
I have a question, how can I create a device upgrade for a device that is already contained in remote's eprom. The reason I want to do this is to arrange the keys as they should be without using key macro.
Thank you.
Posted: Fri Apr 16, 2004 1:20 pm
by The Robman
toranoko wrote:I have a question, how can I create a device upgrade for a device that is already contained in remote's eprom. The reason I want to do this is to arrange the keys as they should be without using key moves.
If you tell us what the setup code is, we can probably look it up somewhere and create a KM file for you. You could also check the file section to see if there's already a file for this device.
When you post the setup code, please start a new thread.