OFA 8910 Device Upgrade

mdavej · Post by **mdavej** » Mon Jan 18, 2016 9:18 am

You really need to do your learns directly from the remote, not through an extender.

In any case, you'll find that nearly all your learns are identical to the upgrade I posted. So that's a waste of time, IMO. I'd start with the upgrade and learn just the commands that are missing.

radunn · Post by **radunn** » Mon Jan 18, 2016 9:39 am

mdavej wrote:You really need to do your learns directly from the remote, not through an extender.

The URC (learning remote) has special battery to send signal to a receiver so I don't have to point directly at the device.

mdavej wrote:In any case, you'll find that nearly all your learns are identical to the upgrade I posted. So that's a waste of time, IMO. I'd start with the upgrade and learn just the commands that are missing.

The upgrade you posted is for RC URC-7780OFA Stealth 12; does this matter?

mdavej · Post by **mdavej** » Mon Jan 18, 2016 9:43 am

For learning purposes only, you must point the original remote directly at your receiving remote. Ignore your extender for now.

All upgrades work with all remotes. That's the whole point of JP1. Just pick your model from the drop-down.

radunn · Post by **radunn** » Mon Jan 18, 2016 11:19 am

mdavej wrote:For learning purposes only, you must point the original remote directly at your receiving remote. Ignore your extender for now.

All upgrades work with all remotes. That's the whole point of JP1. Just pick your model from the drop-down.

Very well, I selected 8910 New from drop down, changed device type to TV; will reassign buttons to my liking, Output to IR, finally upload to remote. It's working!! Again thanks