General questions for creating 1st custom remote bin, help

joseasd · Post by **joseasd** » Tue Feb 12, 2013 4:38 pm

alanrichey wrote:Are you using the Custom Remote for the bravoo+ or a built-in version ?

https://www.hifi-remote.com/forums/dload ... e_id=10647

That file.

alanrichey · Post by **alanrichey** » Tue Feb 12, 2013 5:03 pm

I have run out of ideas then. The CH- on the C2013 BIN file sends NEC1 Device:0 OBC:94 and my S2010 also sends that identical code. I cannot explian why the C2013 works and the S2010 doesn't.

Sorry

joseasd · Post by **joseasd** » Tue Feb 12, 2013 8:29 pm

alanrichey wrote:I have run out of ideas then. The CH- on the C2013 BIN file sends NEC1 Device:0 OBC:94 and my S2010 also sends that identical code. I cannot explian why the C2013 works and the S2010 doesn't.

Sorry

is there a way to edit azbox bravoo+ bin adding the proper channel + that works for me in big sat DSR5000Slim and Axil AD600? (that way i could get the ability to change channels one by one at least)

Also all these STB make my az america reacts with some functions:

big sat DSR5000Slim
Rownsonic 154
Creation DTTR-2001
Radix DT30SCI
Axil AD600

Could this help to clarify if there's a common factor to help the "NEC1 0, whereas the s922 decoded as NEC1 1:127" matter?

Thanks.

alanrichey · Post by **alanrichey** » Wed Feb 13, 2013 5:17 am

Not really. Two of them decode as NEC 0 and the others decode as NEC 1.127. It isn't unusual for devices to react to 2 different protocols so that isn't surprising.

What doesn't make much sense is that NONE of the buttons on the s922 I provided you work. I can't explain that.

joseasd · Post by **joseasd** » Tue Mar 26, 2013 12:34 pm

Thanks a lot for the guidance, i finally made it mysef and is fully working right now.

https://www.hifi-remote.com/forums/dload ... e_id=11808

alanrichey · Post by **alanrichey** » Tue Mar 26, 2013 12:43 pm

What was the problem ?

joseasd · Post by **joseasd** » Tue Mar 26, 2013 12:51 pm

alanrichey wrote:What was the problem ?

My subdevice is 127 (yours is empty) and protocol is NECx2 (yours is nec 1) as it's shown on remotemaster

Same EFC,OBC, HEX.

I saved it as nec 1 but it shows me NECx2, dunno why is that.

That's the only difference i see between our files.

alanrichey · Post by **alanrichey** » Tue Mar 26, 2013 1:40 pm

OK that does make sense. We had already figured out that the sub-device was either 0 or 127. I await a correction from the real experts but as I understand it NEC1, NEXC2, NECx1 & NECx2 are VERY close relatives and can often be interchanged,