Page 2 of 2
Posted: Sun Mar 08, 2020 8:55 am
by agruber11
"Long press of ffwd and req are the skips. So those are correct."
Well I didn't 'long press' the ffwd or rwd buttons -- but the skip codes (i.e. the codes that I bound to the 'skip' buttons in the Device Editor) were what were transmitted on short presses of ffwd or rwd.
Posted: Sun Mar 08, 2020 9:22 am
by mdavej
Point is long press sends different commands than short. So those buttons have 2 commands each. So you need to test both.
Posted: Sun Mar 08, 2020 9:44 am
by agruber11
mdavej wrote:Point is long press sends different commands than short. So those buttons have 2 commands each. So you need to test both.
You are right. I just tried it and long press vs short press does seem to give different results. But the problem is that the bindings are reversed -- i.e. 'long press' gives the binding associated with Rewind, while 'short press' gives the binding associated with 'SkipBack'.
Posted: Sun Mar 08, 2020 10:07 am
by mdavej
That’s ok. I probably got that backwards.
Posted: Sun Mar 08, 2020 11:09 am
by The Robman
Thanks for the settings.bin file agruber11, that does confirm that there are 2 versions of this remote, yours with sig 257502 and the original with sig 257501. I have modified my RDF zip file to include RDFs for both versions.
But I think your RDF is good to go, let me know if you have any problems with it.
Note: I have slightly renamed the RDF (I added v2 to the title), so if you do re-download it, be sure to delete the old one first.
Posted: Sun Mar 08, 2020 11:39 am
by agruber11
The Robman wrote:Thanks for the settings.bin file agruber11, that does confirm that there are 2 versions of this remote, yours with sig 257502 and the original with sig 257501. I have modified my RDF zip file to include RDFs for both versions.
But I think your RDF is good to go, let me know if you have any problems with it.
Note: I have slightly renamed the RDF (I added v2 to the title), so if you do re-download it, be sure to delete the old one first.
Thanks again for all your help. I don't think I'll report any errors -- as I've gotten what I wanted from the remote (the ability to set HDMI inputs -- and transfer these IR codes to my 'real' (non-JP1) remote). I don't actually plan on using the remote again, unless I find I need to add further codes.