Division by zero

[billmunson]

I am using the cable with the JP1 adapter. The cable works -- I can download from the remotes (RS15-2117 and URC 9910). But when I try to upoad I consistantly get the error message: "division by zero".

Any suggestions about what to do?

[The Robman]

Bill, I see that you've been a member for 5 years, so I assume you've done this before. What's changed?

Are you using the latest versions of the software?

[billmunson]

I have a new PC and am now using Tommy Tyler USB cable with the JP1 adapter. I have succesfully used the cable (without adapter) with a URC 10820 JP1.2 remote. With the adapter on a JP1 remote I can download from the remote, but when I upload the same file to the remote I get the "division by zero" message. I am using IR version 8.02

[vickyg2003]

I have a new PC and am now using Tommy Tyler USB cable with the JP1 adapter. I have succesfully used the cable (without adapter) with a URC 10820 JP1.2 remote. With the adapter on a JP1 remote I can download from the remote, but when I upload the same file to the remote I get the "division by zero" message. I am using IR version 8.02

I've always found that making sure my jp1 tools were up to date was a good first step in resolving problems. Version IR 8.03 might have corrected this. Also. you might want to throw in some details about your operating system. Win7? 64bit?

[The Robman]

Well, first things first, you should get the latest 8.03 version of IR, and the latest RDFs. Then, if the problem persists, post a copy of the IR file that you have downloaded from the remote so we can check if there's anything wrong with it.

[billmunson]

I downloaded and installed IR 8.03, and tested it with JP1.2 and JP.1 with the adapter, and both worked great. Thanks Rob for the help!