nFusion HD RID File Needing Assistance with Editing

[pluto30306]

Hoping someone could help me with this question.

I found a nFusion HD Satellite RID for my RTV 4504, created by scarlet fire. I loaded the file via WIRNS...all good. [I don't want to use WIRNS for my channel guide.]

I can't seem to get the file to work with channels below 100 and above 1000 for Dish Network. I use the channel guide and/or I type in the correct number but then goes to the 8000's.

Any advice or editing help?
My ircodeRaw is: Yes^^1014^Yes^1^200^0^300^200^

file is located: http://www.hifi-remote.com/forums/dload ... le_id=6701

Special thanks to scarlet fire for the file!

[The Robman]

You might want to also post this question over in the AVS forum as it sounds like something those folks might be better able to answer.

[pluto30306]

I had an extra space in my shell command.

The RID file is posted here: http://www.hifi-remote.com/forums/dload ... le_id=6701

Thank you for all your suggestions and help.