URC6025 and Thomson

pepelu · Post by **pepelu** » Wed Nov 11, 2009 12:32 pm

Hello:

I have an decoder Thomson for Tv Cabo (this http://www.tecforsis.pt/produto.asp?idproduto=18043) and yesterday, try to set up the remote (URC6025R01-03) with a DVD, I should have make a mistake and the decoder don´t respond now with the remote.

I have tried to look for the code and even "blink out" the code but nothing works.

Somebody can help me?

Thanks.

3FG · Post by **3FG** » Wed Nov 11, 2009 3:02 pm

This is just a guess, and I don't even know if the 6025 has this setup code, but try cable 0856.

Some Thomson Sky boxes respond to this.

pepelu · Post by **pepelu** » Wed Nov 11, 2009 4:27 pm

Can you explain me something more? I don´t know what´s mean "cable 0856"

3FG · Post by **3FG** » Wed Nov 11, 2009 5:28 pm

I'm not familiar with the 6025, but but assuming it is like other URC- remotes.
1) press the device button labeled cable or sat. Other device buttons might be TV, DVD, VCD, Audio, etc.
2) press setup until it blinks twice
3) enter in 0856
You should get two blink if that is a valid setup code.

4) Try it and see if the box responds.

Some newer remotes need a 5 digit setup code. If the 6025 is like that, enter 00856 instead of 0856.

pepelu · Post by **pepelu** » Thu Nov 12, 2009 1:41 am

OK, I´ll try this afternoon.

Thanks.

pepelu · Post by **pepelu** » Thu Nov 12, 2009 11:32 am

Don´t work neither.

MaskedMan · Post by **MaskedMan** » Thu Nov 12, 2009 11:37 am

Try a code search:

1. DTV or STB whatever the device is called
2. press and hold SETUP for two blinks
3. enter 9 9 1
4. enter 2
5. point the remote at the STB and keep pressing & releasing CH UP, if and when the STB powers on
6. press SETUP to lock in code

pepelu · Post by **pepelu** » Fri Nov 13, 2009 1:43 am

Thanks but don´t works neither.

I try too "blink out" the code (enter 990 (i can´t remember) and then 1, 2, 3 and 4) for look how many times the light blink and the code is 0032....but don´t works either.

I´m thinking in try with a One For All remote, if not work that..... the problem can be in the decoder?

MaskedMan · Post by **MaskedMan** » Fri Nov 13, 2009 9:49 am

there is no reason to try blink back now, after entering codes suggested in this thread, and a codesearch, your code has been replaced.

retry the codesearch, but enter 0 in fourth step.

pepelu · Post by **pepelu** » Mon Nov 16, 2009 12:56 pm

I´ve buy a ALL FOR ONE remote and works (looking for the code, not the "official codes"), so the problem is on the original remote.