Dreambox v4 urc-39930 BJ0 error

[dreamy]

Hi all

i have a new dreambox remote no urc-39930r j0-04

when i load the ir software there is an error message "saying coflict at fixed data address $0200 do you want to repace existing data with the fixed data"

the handset is new and did this from first loading i am asuming i use the dreambox v4 rdf version of this

what am i doing wrong

i notice if i say yes the software becomes unstabe when loading new protacols and crashes i am having trouble loading anything in to this remote
i have a version 3 of this remote all set up is there anyway of transfering the data from v3 to this v4

any info would be great

thanks

[dreamy]

All sorted Thanks

[The Robman]

Could you explain how you solved this, just so it's documented for the next person that searches for this problem.

Thanks

[prwoolfall]

Could you explain how you solved this, just so it's documented for the next person that searches for this problem.

Thanks

I have two DB remotes as follows:


URC 39739 BO2

URC 39939 BJ0

Same problem. Just download from remote and then upload to remote. Problem gone and all is well.

[The Robman]

But do you accept the change or not?

[prwoolfall]

But do you accept the change or not?

Yes.

It works OK on both; I use both and have completely re-programmed them.

[binky123]

You may want to download the latest RDF for 10381038 Dreambox V4 from here as that one doesn't have a [FixedData] section in the RDF.

When I was initially building the RDFs for the new remotes, I wasn't sure what the private area was used for so I noted a couple of these bytes as FixedData in the RDF. Subsequent downloads from other users had different data in this area so I removed this section from the RDF. I believe the private area holds initial setup codes and perhaps version info. Initial setup codes would vary depending on the supplier of the STB.