JP1 Remotes

poet99 · Joined: 05 Jan 2004 Posts: 27

I am having all sorts of problems with my JP1 setup (loose 6 pin header, etc.). In short, there is no response from my old URC-6800. Is it possible to reset the remote without JP1?

If not, it is not that bad, I was planning to change the thing anyway.

Thanks

François

johnsfine · Posted: Fri Jan 09, 2004 4:44 pm Post subject:

To deactivate an extender:
1) Remove a battery.
2) Press a key while the battery is out
3) Replace the battery.

To remove an extender without JP1 requires that you first deactivate it, then do a 981 reset (which removes all your settings, keymoves, macros, etc. as well as the extender).
4) Long press of Magic key
5) key in 9 8 1