DirecTv HR20

thinker · Post by **thinker** » Fri Oct 13, 2006 5:41 pm

I uploaded the R15 RM file into my remote for use with the HR20. The menu button is wrong. The MENU button brings up what the ACTIVE button does on the actual HR20. So, this is one button that is not compatible. Does anyone know what the EFC or HEX is for the HR20's RC23/RC24 remote for the MENU button?

thinker · Post by **thinker** » Fri Oct 13, 2006 5:43 pm

http://www.hifi-remote.com/forums/dload ... le_id=2956

should be the newer file with fixes.

bobshults2 · Post by **bobshults2** » Fri Oct 13, 2006 6:09 pm

Try this

http://www.hifi-remote.com/forums/dload ... le_id=3623

MaskedMan · Post by **MaskedMan** » Fri Oct 13, 2006 6:34 pm

Try EFC 019.

dmunjal · Post by **dmunjal** » Wed Nov 15, 2006 11:00 pm

thinker wrote:http://www.hifi-remote.com/forums/dload ... le_id=2956

should be the newer file with fixes.

I just tried this KM file but the 30s skip and skipback don't seem to work. Also, is there a key for the "dash"?

JeradinG · Post by **JeradinG** » Fri Jan 19, 2007 9:51 pm

Hello all,

I downloaded the new HR20 RMDU file at the following link. http://www.hifi-remote.com/forums/dload ... le_id=3623

I am using the URC-9910 with extender, I uploaded it to my remote, and all the buttons seem to point to different functions. I have goen through the RemoteMaster and all seem to be pointing to the right function, but when I use it, the up arrow brings up the menu, and down arrow plays, and well, every button is wrong other then the channel buttons.

Where do I go from here? is it because the RMDU was made for a different remote? or is this a new Version of the HR20?

Thanks for any help in advance!

Dale Jacobs

kupakai · Post by **kupakai** » Fri Jan 19, 2007 10:26 pm

The rmdu file you uploaded is set to a different remote (it's set to URC-881x 1k. Change that to the remote you have, and the copy and paste that over to IR.

JeradinG · Post by **JeradinG** » Sat Jan 20, 2007 6:58 pm

Hi there, thanks for the reply.

Under remote in the RemoteMaster program I had set it to "URC-9910(New) Extender 1" same as what I used for my Sony receiver, Bravo DVD player. Still getting the mixed up keys.

Should I change the protocols? or try it without the "Upgrade Protocol Code" part?

Not sure what else to try.

Thanks!

Dale

incandenza · Post by **incandenza** » Sun Jan 28, 2007 1:32 pm

Hmm, I had the same problem and I eventually got it to work. Unfortunately, I won't be very helpful because I'm not sure exactly what I did differently.

JP1 Remotes

DirecTv HR20

DirecTv HR20

Downloaded, but not working right