Beta JP1.x cable convert cable is available at diygadget.com

prelude · Post by **prelude** » Sat Aug 26, 2006 6:58 pm

We had made some JP1.x cable for testing. The PCB were made based on the May 18 design. Therefore they were missing 2 additional 1K resistors and one additional capacitor. However, it is very easy to add them on our testing cable. We are selling these old design JP1.x cables with two 1K resistors and one 0.1uF capacitor as one package at a clearance price. We have also posted the detailed instructions with images on how to do it. Please check it now at this link.

Price is USD $13.49 with free shipping to USA and Canada.

Thanks

Post by **The Robman** » Sun Aug 27, 2006 11:07 am

With regards to the following line on that page...

If you see "JP1.2" above the IDC header, then your remote is JP1.2 compatible.

I think you should add the following note:

(Note: not all JP1.2 remotes are clearly labelled as such, some are misleadingly labelled as JP1, so if you're unsure which type your remote is, please ask).

prelude · Post by **prelude** » Sun Aug 27, 2006 2:50 pm

thanks, I have updated it.

The Robman wrote:With regards to the following line on that page...
If you see "JP1.2" above the IDC header, then your remote is JP1.2 compatible.

I think you should add the following note:
(Note: not all JP1.2 remotes are clearly labelled as such, some are misleadingly labelled as JP1, so if you're unsure which type your remote is, please ask).