New User of 8910

jbonham · Post by **jbonham** » Sun Jan 29, 2006 12:48 pm

Screenshots of aforementioned programs.

http://oesm.org/images/cortex/remote

jbonham · Post by **jbonham** » Sun Jan 29, 2006 12:55 pm

Just to let you know, the remote rattles. Something I had never noticed before. I will take a look at it and see if it I can re-solder the portion of the modem you spoke about.

jbonham · Post by **jbonham** » Sun Jan 29, 2006 1:42 pm

Glue was all busted up around the modem but am quite sure that the wires are still attached to the board itself.

jbonham · Post by **jbonham** » Sun Jan 29, 2006 2:33 pm

The files you were asking me to post are linked to here:

http://www.hifi-remote.com/forums/dload ... le_id=2749

and here:

http://www.hifi-remote.com/forums/dload ... le_id=2750

Both are for the URC-8910. The outside case has URC-8910B02 but the inside on the board has URC-8910B00. Does this make a difference?

jbonham · Post by **jbonham** » Sun Jan 29, 2006 3:53 pm

All is lost. I checked the modem wiring again and did notice that one of the wires was disconnected from the board. I knew I had to be careful getting it back on but it seems as though I fried the modem. When I try to go to download now it just says error. So, I may be able to get it replaced under the product replacement plan from the store where I bought it but who knows. Funny enough the rest of the remote works fine. Maybe I could just suffer and use the original remote for the receiver from now on. Guess that all depends on if the store will replace it or not. Thanks for all your help and I will post to let you know what happens from here on in.

Post by **The Robman** » Sun Jan 29, 2006 4:08 pm

If you get yourself a $14 JP1 cable, it won't matter whether the modem works.

jbonham · Post by **jbonham** » Sun Jan 29, 2006 5:05 pm

Looks like thats what I will have to do. I am not much for waiting. thats the only reason I have tried the wav file incessantly. I will get a cable ordered this week. Thanks for all your help Rob.