Messed My 9911

jeffp · Post by **jeffp** » Sun Jul 10, 2005 7:12 pm

Hello, all... I programmed my 9911 remote about a year ago... everything was perfect. I have recently purchased a new plasma that I want to control. I need to learn the keys for it, but to do so I need to get back to a virgin image of the remote (I am using the extender). I used to have a base version of my remote that I could upload and use to learn, but it is no longer around.. I tried uploading a new 9911 image onto my remote and tried the mfr reset approaches listed here, but I cannot press and get the correct behavior out of my set key.. can someone upload a fresh 9911 image that I could use to learn my new remote codes? thanks all

Post by **The Robman** » Sun Jul 10, 2005 8:31 pm

Try this...

1) In IR, select Advanced > Initialize to $FF
2) Do an MFR RESET on the 9911 (not an OPS RESET)
3) Download again using IR. This will be a virgin image.

jeffp · Post by **jeffp** » Sun Jul 10, 2005 9:28 pm

That got me far enough to where I could learn some codes, which I all I needed,

Many thanks