9910 MEM FAULT

tideman76 · Post by **tideman76** » Mon May 23, 2005 6:49 am

Hello all,
I have successfully downloaded and uploading using IR to my 9910 remote about 4 times. The last time I tried to upload, the remote's LCD display read MEM FAULT. I was like oh sh**. I then tried to reset the remote to factory defaults using the instructions in the manual. The LCD reads BAD E2. What does this mean? Has anybody else had this problem.

I am using a homemade JP1 parallel cable that has worked fine the first 4 downloads and uploads.

-Kevin (JP1 user in training)

prelude · Post by **prelude** » Mon May 23, 2005 7:06 am

here are two threads probably useful:

https://www.hifi-remote.com/forums/viewt ... =mem+fault

https://www.hifi-remote.com/forums/viewt ... =mem+fault

The little 'search' button at the top is your good friend

tideman76 · Post by **tideman76** » Mon May 23, 2005 7:20 am

Thanks for the links, but I did see those threads before I posted. After reading those threads, I thought I would post a new thread because I have had successful uploads and downloads. I did not get that impression from the other threads.

Thanks for your quick response.

Post by **The Robman** » Mon May 23, 2005 12:32 pm

The bottom line is this:

If you do an OPS RESET, as described in the manual, the problems will persist.

But, if you do an MFR RESET, as described here, the problems should go away.

tideman76 · Post by **tideman76** » Mon May 23, 2005 2:15 pm

Thanks for the replies. I just kept downloading and uploading to the remote and now everything seems to be working just fine. I think I will do the manufacturer reset just to be on the safe side.