My 15-2116 remote has a built-in device code, Audio 1189, that (mostly) controls my Philips receiver. I'd like to modify the device some in KM, but Audio 1189 isn't in Devices4.xls. Is there an easy way to get a KM device file for this? Can it be "extracted" from the remote? (I'll learn from the original remote and decode if I must.) Something tells me I'm missing something simple...
Thanks,
- Jeff
(Oops. Meant to post this in the beginners forum.)
Device in remote (15-2116) but not in Devices4.xls
Moderator: Moderators
-
willcodeforbeer
- Posts: 7
- Joined: Tue Nov 04, 2003 8:15 pm
-
jamesgammel
- Exile Island Resident
- Posts: 394
- Joined: Sun Aug 03, 2003 2:48 pm
- Location: Gillette, Wyoming
Unless someone already knows the protocol, device, and has a list of advance codes for 1189 (and that's an "if" since it might be a combo), the best solution for you may be the obvious one you've already considered, just learn all the buttons, use IR to decode them then make an upgrade in Km based on the info you found. Since it's a Phillips receiver, there's good odds it uses one of the Rx protocols. you could kinda extract the efc's but it would mean doing a keymove for each key, and using IR. I think it'd be quicker and easier just to learn a slew of buttons from the oem, then learn the rest if you can't learn them all in one batch. Seems to me i saw a post recently about audio_1189 fairly recently, but dang if i can remember just where i saw it. May have been here or at RC. In the time it took to just do a search for it, you could have what you needed already by just leanring and haiving IR decode for you. Devices4 only covers setup codes that were in the 1994, which is why you counldn't find anything about it, it's not in a 1994.
Jim
Jim
-
aberguerand
- Advanced Member
- Posts: 259
- Joined: Sun Aug 10, 2003 11:55 pm
- Location: Lausanne, VD, Switzerland