Newbie needs help with 15-2133 Interface

otis597 · Post by **otis597** » Wed Nov 03, 2004 10:22 am

Hi,

I built a simple interface and programmed my 1994 remote.

I soldered pins to the holes on the 2133 remote, I can not read the remote.
Is the pin out the same? Is there a link that has deatails on the connector for this remote?

Thanks!

Otis

Nils_Ekberg · Post by **Nils_Ekberg** » Wed Nov 03, 2004 10:28 am

The pinout is the same on all of the jp1 remotes just some of them are reversed. In other words you may have to just turn the cable connector in the other direction so try both directions.

I don't remember anything unique about the 2133 that would require you to do anything differently.

Post by **The Robman** » Wed Nov 03, 2004 11:15 am

otis597 wrote:I soldered pins to the holes on the 2133 remote

How do you get the batteries in and out with the pins in the way?

JP1 Remotes

Newbie needs help with 15-2133 Interface

Newbie needs help with 15-2133 Interface

Re: Newbie needs help with 15-2133 Interface