JP1 Remotes

charlie · Joined: 08 Oct 2004 Posts: 2

Hi,

This looks like a great site. I hope you can help me with my problem.

My cable company provides me with a Millenium 4 remote for my Motorola DCT. I am very happy with the functionality of the remote except that when it is in CBL mode, and I press the PWR key, it powers off (or on) both the TV and the DCT. I would like it to only power the DCT and leave the TV alone.

Our TV is a micro projector model and it takes it 90 seconds to shut down and a further 60 seconds before we can turn it back on. A little mistake and we're in for a long wait.

Any help with this would be greatly appreciated. If my only recourse is to start playing with JP1 then that is fine. I'm itching to have an excuse to spend some time on that!

charlie

MaskedMan · Posted: Fri Oct 08, 2004 3:41 am Post subject:

Try this:

1. press and hold SETUP for two blinks
2. enter 9-9-5
3. press POWER twice
4. press and hold SETUP for two blinks
_________________
Edmund

charlie · Joined: 08 Oct 2004 Posts: 2

Ah, worked like a charm! Great, thanks a lot.

I pushed the CBL button as Step 1, I'm not sure if that was necessary though.

charlie

[Who was that masked man?]

The Robman · Posted: Fri Oct 08, 2004 10:02 pm Post subject:

MaskedMan · Posted: Sun Oct 10, 2004 12:22 pm Post subject:

Remember the song Rob, "you don't tug on superman's cape, you don't spit into the wind, and you don't pull the mask off of the old Long Ranger" Smile

_________________
Edmund

The Robman · Posted: Sun Oct 10, 2004 2:12 pm Post subject:

I didn't pull off the mask, I just showed people where the answer could be found (assuming you can decode riddles).
_________________
Rob
www.hifi-remote.com
Please don't PM me with remote questions, post them in the forums so all the experts can help!