Extender Setup

kentech · Post by **kentech** » Sat Sep 11, 2004 1:25 pm

While trying to get an extender ready for my new 8810W the batch file needs a . HEX file . My question is where do i get the hex file it was not in the extender download???

kentech · Post by **kentech** » Sat Sep 11, 2004 1:32 pm

sorry found it but now i get an Upgrade pointer at $0000 points to $ffff which is out of range
What do I do to correct this??
Thanks in advance

jon_armstrong · Post by **jon_armstrong** » Sat Sep 11, 2004 5:47 pm

There is a great document specifically for setting up extenders for the URC-8811/8810 have you seen it. It probably is a very good place to start.

kentech · Post by **kentech** » Sat Sep 11, 2004 8:08 pm

Yes I have figured it out and now am learning how to Program the correct functions. Thank you.