View previous topic :: View next topic |
Author |
Message |
difi
Joined: 13 Aug 2004 Posts: 4
|
Posted: Thu Aug 19, 2004 9:14 am Post subject: Physically swapping buttons on OFA remotes |
|
|
This is an easy one to answer to anyone who has popped one open...
If you open the remote, can the same-sized buttons be swapped around on the 8811/8910/etc.? (Or are they attached in some way, shaped differently at under the shell, or otherwise limited to their exact locations.)
I was hoping that I would be able to move around the source buttons to reflect my system usage. |
|
Back to top |
|
|
Mark Pierson Expert
Joined: 03 Aug 2003 Posts: 3017 Location: Connecticut, USA |
Posted: Thu Aug 19, 2004 9:34 am Post subject: |
|
|
The rubber buttons are usually all part of a single membrane. While you could cut out individual buttons (of the same shape) to relocate them, I don't think the finished product would be very appealing or long lasting. It's probably easier to retrain your fingers! _________________ Mark |
|
Back to top |
|
|
|