I am aware this is a rather basic remote, however I have ran into a little issue. A friend lost their old URC7935, and got a replacement. However, the new one will not actually work on the Roku TV fully like the previous one.
I can't seem to get it to work without learning from the OEM remote, however it won't repeat the signal when holding the directional buttons.
Does anyone know what I can do to correct this? If I need to get a 6pin cable, I would appreciate anyone telling me which cable to get for this remote. I have played with Remote Master to get my remote setup for me, but it has a USB connector.
One For All URC-7935
Moderator: Moderators
After the bad learns, factory reset the remote:
1. press and hold the TV POWER button and the Back button.
The Ring should blink yellow twice
2. Press Options, REPLAY and HOME consecutively, the ring should blink RED 4 times
To program the Roku tv:
1. Hold down the STB POWER and HOME buttons until it blinks RED twice
2. press BACK <- <- <- <- <- five times, ring should blink green twice.
1. press and hold the TV POWER button and the Back button.
The Ring should blink yellow twice
2. Press Options, REPLAY and HOME consecutively, the ring should blink RED 4 times
To program the Roku tv:
1. Hold down the STB POWER and HOME buttons until it blinks RED twice
2. press BACK <- <- <- <- <- five times, ring should blink green twice.
Edmund
Thank you! It worked PERFECTLY! My friend is now happily using the remote!MaskedMan wrote:After the bad learns, factory reset the remote:
1. press and hold the TV POWER button and the Back button.
The Ring should blink yellow twice
2. Press Options, REPLAY and HOME consecutively, the ring should blink RED 4 times
To program the Roku tv:
1. Hold down the STB POWER and HOME buttons until it blinks RED twice
2. press BACK <- <- <- <- <- five times, ring should blink green twice.