Beginner advice

hotto · Post by **hotto** » Fri Jun 25, 2021 8:49 am

Hi every body.

My language in english isn,t so good then i m afraid to not understand what i need.

My goal is to delocked in full mode a remote urc 11 -7555B00.

Is it possible to do it ?

If yes , I understood I need a irc files to download and buy a correct cable for my laptop win 7 ?

Thanks for helping me..

Hotto

mdavej · Post by **mdavej** » Fri Jun 25, 2021 9:30 am

Please take some pictures of the buttons and inside the battery compartment, click below and then click the UPLOAD button to post them.
https://www.hifi-remote.com/forums/dload ... &cat_id=35

hotto · Post by **hotto** » Fri Jun 25, 2021 3:48 pm

Hi Dave j
I send the pictures
Hope it is those you need.
Thanks
Hotto
https://www.hifi-remote.com/forums/dload ... e_id=26346

mdavej · Post by **mdavej** » Fri Jun 25, 2021 4:01 pm

Can you get one showing the 6-pin connector and the fully assembled remote.

3FG · Post by **3FG** » Fri Jun 25, 2021 5:11 pm

Based on this post from 2006 I suppose this is just the 10751075 URC 7555 remote. It is a JP1.2 remote, so should work with a typical USB to serial cable.

hotto, I don't understand what you mean by "delocked in full mode". I expect that with a cable you will be able to access the full capabilities of the remote, including making custom upgrade files for equipment that 7555 doesn't have built-in setup codes.

Post by **The Robman** » Fri Jun 25, 2021 6:30 pm

Hotto, if you are trying to program your remote using JP1, all you need is the right cable. Check out the following thread for information on cables that will work with your remote:

https://www.hifi-remote.com/forums/viewtopic.php?t=16360

hotto · Post by **hotto** » Sat Jun 26, 2021 7:50 am

Hi.

Then, I ll buy a cable and come back to you for further infos ...

Thanks !

Hotto

hotto · Post by **hotto** » Wed Jul 28, 2021 10:50 am

Hi,
I have now bought the usb cable with the 6 wires to connect to the remote .
Once done correctly , i plug the usb into the computer (win7 or win10) and execute IR 802..
But my computer doesn't recognise the remote ?
Have i forgotten something ?
Thank you for advices !
Hotto

Post by **The Robman** » Wed Jul 28, 2021 11:15 am

hotto wrote:Hi, I have now bought the usb cable with the 6 wires to connect to the remote

You are only supposed to connect 4 wires to the remote, which instructions were you following?

mdavej · Post by **mdavej** » Wed Jul 28, 2021 1:57 pm

You should also use Remote Master, not IR 802.
https://sourceforge.net/projects/controlremote/

JP1 Remotes

Beginner advice

Beginner advice

Using jp1 for the first time

Re: Using jp1 for the first time