URC 8910 FROZE UP

BigDLondon · Post by **BigDLondon** » Tue Feb 12, 2019 10:40 am

I WAS USING MY URC 8910 Turning off my Bluray player and switching over to TV and it froze up.So I pulled a battery and it came back with whole display showing and inoperable .Any way to fix this.

Post by **The Robman** » Tue Feb 12, 2019 2:17 pm

Pull the battery again, keep it out for a minute or two and press some buttons while it is out.

If it comes back OK but you want to do a master reset to be certain, do this:
* Press and hold SETUP until screen reads "CODE SET"
* Press RECORD
* Follow the prompts

Are you still able to read the remote using RMIR?

BigDLondon · Post by **BigDLondon** » Tue Feb 12, 2019 4:15 pm

I put the battery back in and was able to do a reset .Setup /Rec button /MFG reset and than upload IR config file.Thanks again for saving our bacon Robman.

Post by **The Robman** » Tue Feb 12, 2019 4:51 pm

Glad u got it sorted.