RMIR URC 7980

jts321835 · Post by **jts321835** » Sat Jul 23, 2016 4:48 am

I have macros embedded in activities, I am unable to edit it with RMIR when I try and edit it, it changes the key from button68 to 0, button 68 is not an option in RMIR is there any work around, also I have a requirement to delay a key press because the device takes a little time to boot, is that achievable?

mdavej · Post by **mdavej** » Sat Jul 23, 2016 9:17 am

Sounds kind of like you have an extender loaded in the remote but not in your file. Try reinstalling the extender. You should never see anything like button68.

jts321835 · Post by **jts321835** » Sat Jul 23, 2016 12:53 pm

Thanks for advice, will have a look when I get home it's not something I've custom installed it's default behaviour on the remote.

mdavej · Post by **mdavej** » Sat Jul 23, 2016 3:54 pm

My mistake, there is no extender for this remote that I know of.

In that case there are errors or something missing in the RDF and/or Map. Try to contact the author of the RDF and you guys can work out the corrections that are needed. Then you should be back in business.

EDIT: I see this is a brand new RDF still under development. Try to keep these kinds of questions back in the original thread rather than starting a new one. Otherwise folks like me who are out of the loop may unknowingly give you bad advice.

jts321835 · Post by **jts321835** » Sat Jul 23, 2016 3:59 pm

I see thanks for the advice, will bear that in mind, thanks for your advice, much appreciated.