View previous topic :: View next topic |
Author |
Message |
michaeljc70
Joined: 05 Feb 2016 Posts: 34
|
Posted: Sat Feb 06, 2016 1:02 pm Post subject: Making learned codes functions |
|
|
I found a device using the EZ software for my Polk sound bar and loaded it to my remote. I needed to learn a few keys like Sub+ and Sub-, which I did with the remote.
I loaded that into RMIR and the learned buttons show up on buttons. I saved the device file and loaded into my RMIR setup as a new device. However, I want to map those buttons to another device and I cannot because they are not functions, just buttons.
Do I need to copy the codes from the learned tab to create a function? Is there some other way to get a learned code under functions? |
|
Back to top |
|
|
mdavej Expert
Joined: 08 Oct 2003 Posts: 4501
|
|
Back to top |
|
|
michaeljc70
Joined: 05 Feb 2016 Posts: 34
|
Posted: Sat Feb 06, 2016 2:49 pm Post subject: |
|
|
Thanks. I got it working. Since the codes must already be in the device (since they are assigned to buttons), I thought maybe there was an easier way. Using the copy though, it was pretty easy. I thought I was going to have to move the codes one at a time. |
|
Back to top |
|
|
mdavej Expert
Joined: 08 Oct 2003 Posts: 4501
|
Posted: Sat Feb 06, 2016 3:00 pm Post subject: |
|
|
You can create a new device from all learns with one click, but then you'd have to copy/paste from that new device back to your existing one.
The only numbers you have to enter are the non-zero digits of the OBC, so shouldn't have to type more than 2 or 3 numbers per command. Probably quicker than copy/paste. |
|
Back to top |
|
|
|